This month I’ll start with my mantra: There are no toxic plastics. Our detractors have been very active of late, saying whatever they need to make plastics seem dangerous. Latest is the meme that if a goat eats a plastic bottle, it may not be excretable, prevent normal eating and may even cause its death. Sounds like what some people do with bariatric surgery. Never mind that the bottle may have given a consumer needed energy, or some pleasure, or even better health if it contained water rather than sugary drinks. Now is the hard part: These believers are not stupid nor even uneducated. They don’t want to know that there are no toxic plastics, as it interferes with their image of plastics as corporate, unnatural and chemical. There’s more, but I’m here to talk about extrusion, and this month the topic is color.
The painter Claude Monet used to go to the same place—the cathedral in Rouen—at different times of the day to paint what he saw. He knew the light would be different in the morning, at noon and in the evening, and, therefore, so would the colors. So here’s the first rule of color: Compare and control quality by always measuring in the same light. The appliance and vehicle industries know this well—you won’t sell into these industries without a clearly defined color specification, unless you’re supplying a maker of cheap replacement parts, which may have other problems, too. Game supply and game card sleeve and trading card sleeve and soft card holder
Another problem that besets extruders of colored products (and molders, too) is yellowing. This is the natural result of oxidation, which usually means overheating. A model case is the search for a blue dye to make a clear blue PET bottle to hold water. Pigments don’t work, as they are solids and reduce or eliminate clarity. And PET is a problem because it runs much hotter than most other plastics. That may cause reaction of the (organic) dye, and if run just a little too hot the natural yellowing of the resin will push the color away from blue-blue toward green-blue. Also, yellowing may change the physical properties of the resin, which may or may not be important. Game supply and game card sleeve and trading card sleeve and soft card holder
Black is deceptive. You would think that if it’s black no one cares about the color, but there are many “shades” of black. Art students and experts may know Ad Reinhardt who mixed a little green or red or blue with a mostly black mass of paint. It takes time to tell the differences, but most of us can do it. Color measurement devices can do it right away. Game supply and game card sleeve and trading card sleeve and soft card holder
Gloss matters, too. That’s obvious if you think about it, but it needs a measurement (ASTN D523) of how much light is reflected, and the angle of the test must be specified. One of the big differences between molding and extrusion is that the mold imparts the gloss, and almost any resin can be glossy. In extrusion, the gloss is much more resin-dependent. Higher melt temperature adds gloss but has other drawbacks and sometimes can’t be used. Sheet is made shiny by cooling it on chromed rolls, but this gloss may be lower if the sheet is then reheated for forming. Some profiles can be radiant-heated or even buffed on line to add gloss, or sandblasted (ground organics like nutshells) to lower it, although this tends to be done with fillers and other additives (including cross-linked PVC, a little-known material). With fillers, pay attention to particle size and shape, as well as surface treatment. All “calcium” is not the same. Game supply and game card sleeve and trading card sleeve and soft card holder
Mixing is very important, and often controls what colorants are bought/used. A once-important SPE ANTEC paper (Kovach) showed how better/more intense mixing could lower material costs by getting 3% of a given concentrate to give the same coloring effect as 4% when less thoroughly mixed. Game supply and game card sleeve and trading card sleeve and soft card holder